Indoor Heli controller (as EasyCopter V6, Lama2), 6 LEDs 3 mm: 2x Position / 2x Flashing / 2x Landing. Power 1S LiPol. NonControlled
You can order a separate unit or together with the LEDs and cables as a set.
Set contains: Controller NF-3m-H1, LED 3 mm/10 mA (1xG, 3xR, 2xW), cables
Illumination Unit NF-3m-H1
NF-3m-H1 (previously NF-3mECV6) unit is a reduced (smaller) version of NF-3RC designed for illumination of small "Indoor" and "ParkFly" models with color ultra bright LEDs (Light-Emitting Diodes) 1.8mm, 3mm or 5mm. It can be used also for illumination of plastic models with SMD LED diodes. It can power six lights: one green position light P1, one red position light P2, two flashing lights F1 and F2 ( red or white) and two white landing lights L1 and L2. This is version for small helicopters and is espetially designed for helicopters with 1S LiPol 3,75 V or 4 V Accu on board like EasyCopter V6, new Blade or new Lama
The unit offers eight different flashing combinations for F1 and F2 with one second period. See the diagram on the left side. One of those combinations can be selected by jumpers 1, 2, 4. The sum of numbers of the connected jumpers represents the number of the selected combination.
Installation procedure: The typical unit connection is shown by the scheme below. Color as well as position of diodes in a specific model may vary. The unit is connected to the accumulator in parallel with the circuits of the model. The red wire of the unit must be connected to the positive pole of the accumulator, the brown wire to the negative pole. Be careful, the reversal of polarity can destruct the unit.
You may check the function of the unit by connecting it to the accumulator and by putting diodes on the unit’s contacts. In that way it is possible to check the diode’s color as well. When connecting the diodes to the unit one must observe the polarity. The positive pole has a longer outlet (a) The negative pole has a trimmed edge (b) and usually extends inside the body (c) to hold the chip. See the picture. The reversal connection of diodes to the unit is not destructive. DO NOT TRY to test the diodes by connecting them directly to the accumulator. Without a compensating resistance you would destroy the diodes.
|Wingspan From (cm)|
|Wingspan To (cm)|
|Weight of one LED (g)||0,13g - 0,17g|
|Operational Temperature (°C)||0-70°C|
|Unit Cable Length (mm)|
|Number of Flash Sequences|
|Flash Lights 1||1 x Red or White|
|Flash Lights 2||1 x Red or White|
|Position lights 1||1 x Green|
|Position lights 2||1 x Red|
|Landing Lights 1||1 x White|
|Landing Lights 2||1 x White|
|The operating voltage (Min)||3,5V|
|The operating voltage (Typ)||4,0V|
|The operating voltage (Max)||5,5V|
|Consumption (Max)||30mA (5,5V) / 10mA (3,5V)|
|Number of Circuits|
|Package Contains / Information|
|Total Weight of Set|