Candle flame or kerosene lamp imitation set (4.5 - 5.5 V) with one bi-color LED 3 mm for scaled historical boats, controlable by Rx ( max 5,5 V).
Flame Simulator NF-Fire1
NF-Fire1 module serves to simulate flame of a candle or a kerosene lamp. The flame is simulated by bicolor Red/Green LED 3 mm or 5 mm. To increase the reality the light intensity and the color of the flame change in pseudo-random period like a candle in the wind. The intensity of the light can be controlled by receiver.
The module is connected to receiver with a Graupner, Hitech type connector. Red color starts to light at the beginning of the range. The color of the light changes to yellow from the middle of the range. The module is designed to work with BEC of the receiver but.it can also work uncontrolled. In this case disconnect the orange signal and connect the red wire to + pole of the accumulator and the brown wire to the - pole. In this case the light intensity is 100% (full intensity). It works from 3,35 V. Maximum voltage is 5,5 V (also for BEC).
The module has two outputs, one for red color and the second for yellow/green color. The brown output (ground) is negative pole of LEDs (kathodes) and is common for both colors.
|Designed for||Fire Simulation, Candle Simulation, Ships|
|Wingspan From (cm)||N/A|
|Wingspan To (cm)||N/A|
|Weight of one LED (g)||0,22|
|Operational Temperature (°C)||0-70°C|
|Number of Flash Sequences||1|
|Flash Lights 1||N/A|
|Flash Lights 2||N/A|
|Position lights 1||N/A|
|Position lights 2||N/A|
|Landing Lights 1||N/A|
|Landing Lights 2||N/A|
|Voltage||3,35V - 5,5V|
|The operating voltage (Min)||3,35V|
|The operating voltage (Typ)||5,0V|
|The operating voltage (Max)||5,5V|
|Number of Circuits||1|
|Package Contains / Information|
|Control unit||NF-Fire 1|
|LEDs||1 LED R/G 3mm or 5mm|