Large size

Controllers are the lighting control units designed for a wide variety of types and sizes of airplanes, helicopters and UAVs models. The unique feature is that the outputs maintain the nominal current of LEDs in the wide range of voltage without the need to connect compensating resistence series in the circuit. Unit power input is protected against reverse polarity and they are short ciucuit resistant. The units for bigger models have a built-in filter against interference. Light circuits are galvanically isolated from the receiver.

You can order a separate unit or „set“ that additionally contains a corresponding number of LEDs of different colors and cables. The set is not intended as distinct from the „kit“ for a particular aircraft type. The cables need to be measured and LEDs soldered. The kit comes with ready-made cables with soledered LEDs and connectors tailored to the particular model type (see Category Kits). Cables, LEDs or other accessories can be ordered as needed separately as well.

Product Compare (0)

NF-2E (Former NF-2X-350)

Controller for WW2 warbirds or to localise planners, outputs for 20/120/350 mA LEDs: 1x Position / 1x Flashing / 1x Landing. Power 6 V-14 V. 2p3p control.

You can order a separate unit or together with the LEDs and cables as a set.

Set contains: Kontroler NF-2E, LED 100 mA (1xW), 150 mA (1xG, 1xR), 350 mA (1xR) and reflector 20 mm / 350 mA (1xW), cables

872.00Kč

NF-3EF-N (Former NF-3X-F700)

Additional Flash Controller, for wingspan from 1,0 m to 2,0 m. Outputs for 350/700 mA LEDs: 2x Position / 2x Flashing. Power 6 V-14 V. 2p3p Control Mode

1,018.00Kč

NF3E

Controller for big planes with wingspan between 1,0 - 2,0 m. Outputs for 20/120/350 mA LEDs: 2x Position / 2x Flashing / 1x Landing. Power 6 V-14 V. 2p3p Control Mode.

The unit is an innovative product, newly equipped with an electronic power supply switch that can automatically disconnect the unit from the power supply when the receiver is switched off. This feature can be turned off by inserting a black jumper SW, then the unit will act as the original NF-3E.

You can order a separate unit or together with the LEDs and cables as a set.

Set contains: Controller NF3E, LED 5 mm / 20 mA (2xW), 9 mm / 120 mA (1xG, 1xR), 350 mA (1xR, 2xW) and reflector 20 mm / 350 mA (1xW), cables

INNOVATIVE PRODUCT!

1,182.00Kč